What you'll need:
* New Zippo wick: Make sure to use a genuine Zippo wick for optimal performance.
* New Zippo flint: It's recommended to replace the flint at the same time as the wick.
* Small screwdriver: A standard Phillips screwdriver will do.
* Scissors: To trim the wick.
* Zippo lighter fluid: To refill after replacing the wick.
Steps:
1. Remove the insert: Use the screwdriver to loosen the hinge pin located on the bottom of the lighter. Once it's loose, the insert will slide out.
2. Remove the old wick: Pull the old wick out from the insert. You may need to use your fingers or a small pliers.
3. Install the new wick: Thread the new wick through the hole in the bottom of the insert. Make sure the wick is completely inside the insert and the cotton end is exposed.
4. Replace the flint: Remove the old flint from the flint wheel mechanism using a pair of tweezers or pliers. Insert the new flint into the flint wheel mechanism.
5. Trim the wick: Use scissors to trim the wick to the desired length. The optimal length is about ? inch above the top of the insert.
6. Reassemble the lighter: Slide the insert back into the lighter and tighten the hinge pin.
7. Refill with lighter fluid: Add Zippo lighter fluid to the insert and let it soak for a few minutes.
Important Tips:
* Always use genuine Zippo parts. Using counterfeit parts can damage your lighter.
* Be careful when handling the lighter insert. The mechanism can be delicate.
* Do not overfill the lighter with fluid. It can cause spills and leaks.
* Never light a lighter while it's being refilled.
By following these steps, you'll have a fresh wick and flint in your Zippo lighter, ready for a reliable flame.